【求助】最近电脑老是卡机蓝屏,望大虾相助

junjun1898

最近电脑老是蓝屏,运行时不定时的会卡,有时听MP3也会卡,电脑配制是CPU6320,硬盘西捷SATA2, 80G,其他都是主流品牌的不一一写了,以前运行都很OK,最近老是卡,或蓝屏,重装了多次系统和驱动都这样,望这里的大虾帮我看看是怎么回事,以下有蓝屏的图和硬盘测试图,硬盘速度很不正常啊

str82

这个蓝屏信息参见下面这些信息
SYMPTOMS
A computer that is running Microsoft Windows XP or a later operating system stops responding during resume from standby, and you receive the following KERNEL_DATA_INPAGE_ERROR stop error message:
0x0000007a (e163a3e4,c000000e,bf8e9313,0697f860)
or
0x000000F4 (0x00000003, Parameter2, Parameter3, Parameter4)
Note Parameter2, Parameter3, and Parameter4 in the stop error may vary.

This problem occurs on a computer in which Windows XP or a later operating system is installed on a hard disk that is configured as a subordinate and no other device is connected to the same IDE controller channel (primary or secondary).
Back to the top

CAUSE
This behavior may occur when you use Windows XP or a later operating system with some motherboards. Microsoft is researching this problem and will post more information in this article when the information becomes available.
Back to the top

RESOLUTION
To resolve this behavior, use one of the following methods:• For Parallel Advanced Technology Attachment (PATA) hard disks, configure your disk drive as master only. For Serial Advanced Technology Attachment (SATA) hard disks, connect the hard disk cable to a master channel SATA connector on the motherboard.
• Connect another device as a master, such as another disk drive or a CD drive or DVD drive.
• Change your PATA and SATA IDE cable even if the cable does not appear worn.
• Install Windows on a new hard disk because it is possible that your hard disk or your Windows installation may be corrupted.

Back to the top

MORE INFORMATION
Steps to reproduce the behavior
1. For PATA hard disks, set the hard disk jumper to slave mode. For SATA hard disks, connect the hard disk cable to a slave channel SATA connector on the motherboard.
2. In BIOS power management, set BIOS to S1 or S3 (STR).
3. Install Windows XP Professional with Service Pack 1 or Service Pack 2.
4. Restart the computer.
5. Set the computer to Standby.
6. Try to resume the system. The system stops responding.

junjun1898

老大,我不懂英文啊,能解释一下么

str82

大意就是  windows xp和某些主板不兼容  建议你把硬盘和光驱分别接在单独的数据线上 并把跳线设置为master

ourai

怎么设置呢。

ztbyron

先换根好的硬盘线，用MHDD扫下硬盘 硬盘正常的话换条内存看看~~再不行的话换个电源

ztbyron

另外还要看看别是软件问题~~

junjun1898

谢谢大家,我刚联系了电脑公司,打算把盘拿去换一个,这个保5年的吧,听他们说返厂去修基本都是换个新的来

junjun1898

**\ 忘说了西捷的返修效率不太高,听说慢的话要2个月,快的也要1星期哦

ztbyron

直接去找西节的售后 这样速度更快些，另外确实现在多数都是直接换 但换回来的是良品 拿到新盘后，还是要进行一下全面扫描才放心